![]() ![]() More often than not, SeaTools for Windows will test with a PASS status. ![]() Upon completion of running the diagnostics, a log for each drive is saved to the RAM drive. You can abort the test at any time without harming the drive, although the drive will not be fully tested if the test is aborted. Select the Abort Tests icon from the menu bar. ![]() The SeaTools performs a data-safe test of the selected hard disc drive or device for possible malfunctions. Unfortunately, this 10% granularity is an industry standard. Please do not abort the Long Drive Self Test unless an adequate length of time has elapsed to complete the first 10%. The apparent lack of activity often gives the impression that the drive or software has stopped responding. On large drives, 10% progress may take as much as 15 minutes. During the “Long Drive Self Test” progress is reported in 10% increments only. The highest capacity drives often take 2 to 4 hours to complete. Because the long tests read every sector on the drive, the amount of time required will depend on the speed and capacity of the disc drive. The long tests will take time to complete. Consider running the long Generic or long DST test, which reads each sector on the drive if you need a more comprehensive test. The “Short Drive Self Test” is adequate for most situations. When you launch the “ Short Drive Self Test” (DST) most drives will run a thorough diagnostic routine that is built in to the hard drive’s firmware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |